Search results vw collection
No results were found for the filter!
mad level springs
46714
mad reinforcing springs support the series chassis at higher payloads. The driving characteristics of the vehicle are maintained even when it has to perform very hard work.
The springs ensure that the driving characteristics in the unloaded condition correspond to those of the series, as the payload increases they take up their work and ensure that the accustomed driving comfort and the necessary safety are available. The vehicle does not sag, thus maintaining driving safety and ground...
€775.95
*
not in stock, can be ordered
in 7 day(s)
in 7 day(s)
Currently not in stock, can be ordered
in 7 day(s)
in 7 day(s)
Additional pneumatic spring Crafter/Sprinter from models 96-6/06
464991
dual-tyres, super single 4,6t rear axle except ALB/levelling. MB Sprinter 906 OK/KA/AC30-36, VW Crafter 2EKE1-2/2EC1-2 from models 96 - 6/06.
VB-Autolevel VW T5/T6
46556
With this module it is possible to weigh the vehicle, even if the vehicle is parked on an uneven surface. The vehicle is quickly and easily weighed by pressing a button on the control unit.
VB SemiAir 2-circuit auxiliary air spring basic system - MB Sprinter / VW Crafter from 2006
465611
On leaf-sprung vehicles, an air bellows is mounted between the frame and the rear axle to support the existing leaf springs. The VB-SemiAir is supplied as a two-chamber system, so the air bellows are not connected to each other. Two-circuit systems ensure that small load differences can be compensated for separately on the left and right. The VB-SemiAir is supplied with a drain/fill valve for this purpose. Explanation of single circuit/double circuit system: Single circuit system: Both air...
€759.00
*
not in stock, can be ordered
in 5 day(s)
in 5 day(s)
Currently not in stock, can be ordered
in 5 day(s)
in 5 day(s)
€5,551.00
*
not in stock, can be ordered
in approx. 1 - 2 months available
in approx. 1 - 2 months available
Currently not in stock, can be ordered
in approx. 1 - 2 months available
in approx. 1 - 2 months available
Additional pneumatic spring cross country VW T5
46504
Cross-country for more ground clearance between 25-50mm. For a better performance at rough roads. Incl. Synchro front axle approx. 45mm higher, rear axle approx. 30mm higher, approx. 50mm higher.
VB-FullAir 4C VW T6 front and rear axle
46557
Installation of full air springs only possible at specialist dealers trained by VB-Airsuspension! Installation possible at REIMO Egelsbach.
coil springs for the front axle VW T5 year 1994-2006
46567
The reinforced coil springs VB-CoilSpring ensure that the original vehicle level is reached again. In terms of calculation, you get "residual spring travel" again. In most cases, the frame lies almost on the stop buffer, but the increase in the residual spring travel means that the vehicle does not break through as quickly and becomes more comfortable.
Replacement spring for rear axle VW T5 from 6/06 on
46569
The reinforced coil springs VB-CoilSpring ensure that the original vehicle level is reached again. In terms of calculation, you get "residual spring travel" again. In most cases, the frame lies almost on the stop buffer, but the increase in the residual spring travel means that the vehicle does not break through as quickly and becomes more comfortable.
Additional air spring double bellows Sprinter 209-324 as of 2006
46482
For Mercedes Sprinter 209-324 and VW Crafter from 2006. Suitable for flatbed and panel vans. Unterschien is the additional air spring for flatbed and panel vans with straight or inclined axle support. The air spring is ideally suited to compensate for unfavourable loading situations, long overhangs or high centres of gravity, to reduce swinging and to reduce crosswind sensitivity. With the proven dual-circuit system, wheel-side unloads can be compensated and vehicles hanging at an angle can...
€769.00
*
not in stock, can be ordered
in 7 day(s)
in 7 day(s)
Currently not in stock, can be ordered
in 7 day(s)
in 7 day(s)
SMV air spring systems for the rear axle
46493
Suitable for alcove vehicles and integrated motorhomes. For panel vans that are continuously loaded and unloaded. Only vehicles with ABS can be loaded. The air spring systems are generally supplied as 2-way systems, so they can vary the operating pressure right and left if required. Supplied with 2 pressure gauges, 2 valves, small parts, suitable assembly material and TÜV certificate.
2 variants: Air spring Z6 = triple bellows with approx. 6 inch diameter or air spring Z8 = double bellows...
SMV air spring systems for the rear axle
46494
Suitable for alcove vehicles and integrated motorhomes. For panel vans that are continuously loaded and unloaded. Only vehicles with ABS can be loaded. The air spring systems are generally supplied as 2-way systems, so they can vary the operating pressure right and left if required. Supplied with 2 pressure gauges, 2 valves, small parts, suitable assembly material and TÜV certificate.
2 variants: Air spring Z6 = triple bellows with approx. 6 inch diameter or air spring Z8 = double bellows...
€953.00
*
not in stock, can be ordered
in 7 day(s)
in 7 day(s)
Currently not in stock, can be ordered
in 7 day(s)
in 7 day(s)
Additional air springs - 2-circuit basic set MB Sprinter 409-524/VW Crafter 35-5
465612
In vehicles with leaf suspension, an air bellows is mounted between the frame and the rear axle to support the existing leaf springs. The VB-SemiAir is supplied as a two-chamber system, so the air bellows are not connected to each other. 2circuit systems ensure that small charging differences can be compensated for separately on the left and right. The VB-SemiAir is supplied with a drain/fill valve for this purpose. Explanation Single/two-circuit system: Single-circuit system : Both bellows...
€759.00
*
not in stock, can be ordered
in approx. 1 - 2 months available
in approx. 1 - 2 months available
Currently not in stock, can be ordered
in approx. 1 - 2 months available
in approx. 1 - 2 months available
AirLift Maxi fits Mercedes & VW Crafter FWD from 2006 - 6" two-circle
467614
With two large-volume double bellows, the Linnepe AirLift Maxi brings an enormous level of driving safety at an affordable price. Due to the high chamber volume, the air bellows take on any load that arises. The AirLift Maxi is supplied as a 2-circuit system with compressor. With a lifting capacity of up to 2.5 t per bellows, the system is a real powerhouse.
€1,029.00
*
not in stock, can be ordered
in approx. 2 - 3 months available
in approx. 2 - 3 months available
Currently not in stock, can be ordered
in approx. 2 - 3 months available
in approx. 2 - 3 months available